The most effective method to Check and Replace the Belt Nivåvakt in a Whirlpool 27 Inch Electric or Gas Dryer

1.            Open the entryway on the dryer and attempt to turn the drum either clockwise or counterclockwise. Provided that you could turn the drum effortlessly without much safety, doubtlessly you have a broken or crashed cinch.

2.            Disconnect the dryer from the divider outlet

3.            Open the toe board and look to check whether the sash is broken or recently crashed from the engine & idler pulleys

4.            If the sash is broken you will displace it and provided that it has crashed from the engine & idler pulleys and the cinch looks fit as a fiddle, just reinstall it

The most effective method to disassemble the dryer

1.            Open the controls board

2.            Unscrew the 3 top board holding screws and uproot the top board

3.            Remove the toe board

4.            Disconnect the entryway Nivåvakt from the wire tackle

5.            Unscrew the holding screws from the front board and uproot the front board

6.            Remove the drum from the dryer

7.            Now you could check the sash Nivåvakt and the Nivåvakt actuator

The most effective method to check & reinstate the sash Nivåvakt

1.            Disconnect the wires from the sash Nivåvakt

2.            Set your multimeter on the least scale to read ohms

3.            Make beyond any doubt that the idler pulley's arm is not pushing on the sash Nivåvakt actuator

4.            Take a perusing between the 2 terminals on the Nivåvakt

5.            The perusing ought to be near 0 ohms in place for the power to have the ability to stream to the engine

6.            If the perusing is unendingness, the sash Nivåvakt is terrible and it must be displaced

The most effective method to reinstate the Nivåvakt

1.            Unscrew the 2 holding screws and uproot the Nivåvakt with the actuator

2.            Install the actuator on the new Nivåvakt

3.            Set the new Nivåvakt set up and fasten the holding screws

The most effective method to assemble the dryer back

1.            Set the drum set up verifying that the drum is riding on top of the back drum underpin rollers

2.            Place the sash around the drum. Verify that the edges on the sash are confronting the drum

3.            Get on the floor and stick your hands under the drum. Get the cinch and make circle and place it around the idler pulley

4.            Push the idler pulley to your left and place the sash on the engine pulley

5.            Install the front board and secure it with the holding screws

6.            Connect the entryway Nivåvakt to the wire saddle

7.            Install the top board and secure it with the holding screws

8.            Close the controls board